54480 Ultra-Lite

COMPETITION USE ONLY!  For use in all 9mm & .40 full size and compacts that utilize a firing pin block safety.

Includes our Made in the USA  S-7 tool steel extended firing pin with matching spring and tempered spring steel firing pin retaining pin.   Also includes our 8.5# (HS-8500) hammer spring for use with Federal Primers only.

Includes our 11.5# (HS-12000) hammer spring for use with most primers.

NOTE:  Does not fit the P-07/09, 97B/BD, Canik/TriStar, Shadow 1 & 2, RAMI, Pre-B 75, or P-10 series.



Tutorial for All CZ

TECH TIP:  We suggest a 3mm roll pin punch for removal of the firing  pin retaining pin from the slide.  Use this same punch as a guide for lining up the flats on the firing pin, then drive in the new CGW 61100 tempered steel firing retaining pin from the left hand side.  Be sure and orient the 61100 with the open end “up” at the 12 0’clock position.